top of page

How to Set Up Your Desktop Aquarium

3 days ago
3 min read

Welcome to your new aquarium! Whether you’re setting up a 40oz Micro Tank, a 1 Gallon Small-In-One, or a 5 Gallon Small-In-One XL, the basics are the same. Find a good spot, set up your equipment, add your rock and water, and give the tank time to settle in.


Start with the guide for your tank

Use the steps below for any PNW Custom desktop aquarium. For details like where the pump goes, how the filtration fits together, and where to fill the tank, follow the walkthrough for your model.


1. Pick a spot you’ll enjoy every day

Choose a flat, level surface that can support the aquarium once it’s filled with water, rock, and sand. Keep it away from direct sunlight and heating or cooling vents, and leave enough room to lift the lid, reach the filtration, and do a water change. A spot you pass every day makes it easier to notice when the water level drops or the pump flow slows down.


Blue-lit tabletop with a potted succulent beside a small glass aquarium, white rocks inside and a glowing lamp above

2. Unbox and assemble your equipment

Lay everything out so you can see what came with your kit. Install the return pump, filter media, and any plumbing your model uses, then mount the light. If your setup calls for a heater, position it according to its instructions. Keep the pump and heater unplugged until the aquarium is filled and both are at their required operating water levels.


Assorted electronics accessories on a white table, including a magnifier, cables, adapters, a clear case, and a Power Adapter label.


3. Add your media basket

If your aquarium uses a media basket, slide it into the filtration chamber according to your model’s setup guide. Place the filter pad where water enters the basket so it catches debris before the water reaches the rest of your filter media. Make sure the basket is seated properly and that you can still lift it out easily for cleaning.


If your tank uses separate sump filtration, like the 40oz Micro Tank, follow your model’s guide for where to place the filter pad and other media.


4. Add your aquascape and sand

Try a few rock layouts while you can still reach everything easily. For a reef, leave some open space for water to flow around the rock and a few spots for corals to grow. Make sure the rock sits securely so it can’t shift, and leave enough clearance along the sides for your algae scraper. If you’re using sand, add it around the base of the rockwork once the rock is stable.


5. Fill the tank and check the flow

For a reef, use premixed saltwater with RODI water in a separate container and check the salinity before filling. Pour slowly over a small plate or clean bag to keep from stirring up the sand.


Fill according to your model’s instructions, then start the pump. Check that water is moving through the filtration and returning to the display, and look for leaks around any fittings. Once the pump is running steadily, check the operating water level again and note where it sits. That gives you a reference for future top-offs.


6. Let the tank cycle before you stock it (besides corals!)

Once the equipment is running, give beneficial bacteria time to establish on the rock, substrate, and filter media. These bacteria process ammonia, which can build up from waste and uneaten food. Use water tests to confirm the cycle is complete before adding fish or cleanup crew invertebrates.


If you’re setting up one of our Plug-N-Play reef kits, your corals can be added right away since they are not affected by ammonia, and this actually helps start colonizing the beneficial bacteria in your tank.


Want to follow along on video?

Visit the PNW Custom YouTube channel for setup walkthroughs, tank builds, and practical tips for desktop aquariums. We’re always filming more videos, with more tank setups coming soon.


Where to go next

bottom of page